Nortel Meridian 1 Option 11C, Administration And Maintenance

Page: 359 / 507

Chapter 8 — Service changes and maintenance Page 345 of 492
Option 11C ISDN BRI Administration and Maintenance
DN n...n,Xn...n,
<cr> Directory number to be associated with TSP
The values for this prompt are:
n...n=Adds a 4 to 7-digit directory number
Xn...n=Removes a 4 to 7 digit directory number
<cr>=Stops this prompt from being displayed again
This prompt is repeated until <cr> is pressed. At least
one DN must be assigned to a DSL.
The directory number cannot be shared by a non-ISDN
BRI terminal.
The directory number can be associated with multiple
TSPs on a DSL but it cannot be associated with any
other DSL.
If you remove the directory number that is also
assigned as a default directory number, a new default
directory number must be defined at the DFDN prompt.
CT VCE DTA XVCE
XDTA Directory number call type
The values for this prompt are:
VCE=Adds circuit switched voice
DTA=Adds circuit switched data
XVCE=Removes circuit switched voice
XDTA=Removes circuit switched data
One or more call types can be entered. by separating
each entry with a space. The call types entered must
have been specified for the B1CT and B2CT prompts in
the
DSL configuration procedures.
MCAL 1-(4)-8 Maximum number of calls per DN at one time
Defines the maximum number of calls allowed for the
directory number, which includes active calls, calls
waiting, and calls on hold.
CLIP (YES),NO Calling line identification is displayed on the called
terminal for incoming calls if CLIP is set to YES.
PRES (YES),NO Allows calling line identification presentation as default
The key on the calling terminal toggles the presentation
status on a per call basis to allow or restrict sending
calling line identification to the called terminal.
Prompt Response Comment