Nortel Meridian 1 Option 11C, Administration And Maintenance

Page: 349 / 507

Chapter 8 — Service changes and maintenance Page 335 of 492
Option 11C ISDN BRI Administration and Maintenance
LTEI n1 n2 m <cr> Note: A response to this prompt is only required for
packet data implementation.
The Logical Terminal Endpoint Identifier(LTEI) is used
to address D-channel packet data terminals.
LTEI consists of two components:
n1 and n2 = Logical Terminal Identifier (LTID)
m = Static Terminal Identifier (TEI)
The maximum number of Logical Terminal Endpoint
Identifiers (LTEIs) that can be configured is defined
above by the prompt MTEI.
The ranges for all entries are:
n1 = Logical Terminal Group (LTG) = 1-15
n2 = Logical Terminal Number (LTN) = 1-1023
m = Static TEI = 0-63
Note: LTG=15 and LTN=1023 is an invalid
combination.
Xm=Deletes LTID and TEI as a pair for the specified
TEI.
MCAL 2-(16)-32 Maximum number of calls per DSL
MTSP 1-(8)-16 Maximum number of TSPs
Can be changed to a smaller number only if the TSPs
defined for this DSL do not exceed this number. If they
do, remove all extra TSPs before changing the
maximum number of TSPs.
PGPN 0-15 Protocol group number
The protocol group must be previously added.
PRID 1-5 Protocol ID
The values for this prompt are:
1=ANSI
2=ETSI NET3
3=DMS
4=INS NET64
5=Numeris
PDCA (1)-16 PAD TABLE # — only prompted if PRID=ETSI NET3,
INS NET64 or Numeris
FDN n...n
Xn...n Flexible CFNA directory number
Enter a directory number from 1 to 13 digits long. Enter
Xn...n to delete the parameter.
Prompt Response Comment