92
Configuring Security using the CLI
Parameters and
variables
Description
ATTENTION
If you omit this parameter, the system uses the
port number that you specified when you issued
the
interface
command.
init
Reinitiates EAP authentication.
status
authorized|unauth
orized|auto
Specifies the EAP status of the port:
•
authorized
— Port is always authorized.
•
unauthorized
— Port is always unauthorized.
•
auto
— Port authorization status depends on the
result of the EAP authentication.
traffic-control
in-outIin
Sets the level of traffic control:
•
in-out
— If EAP authentication fails, both
ingressing and egressing traffic are blocked.
•
in
— If EAP authentication fails, only ingressing
traffic is blocked.
re-authentication
enable|disable
Enables or disables reauthentication.
re-authentication
-period
<1-604800>
Enter the number of seconds that you want between
re-authentication attempts.
Use either this variable or the reauthentication-interval
variable; do not use both variables because they
control the same setting.
re-authenticate
Specifies an immediate reauthentication.
quiet-interval
<num>
Enter the number of seconds that you want between
an authentication failure and the start of a new
authentication attempt; the range is 1 to 65535.
transmit-interval
<num>
Specifies a waiting period for response from supplicant
for EAP Request/Identity packets. Enter the number of
seconds that you want to wait; the range is 1-65535.
Nortel Ethernet Routing Switch 2500 Series
Security — Configuration and Management
NN47215-505 (323165-B)
02.01
Standard
4.1
19 November 2007
Copyright © 2007, Nortel Networks
.
Summary of Contents for 2526T
Page 227: ......
