Securing your system
69
default snmp trap link-status command
The
default snmp trap link-status
command disables the
linkUp/linkDown traps for the port. The syntax of the command is:
default snmp trap link-status [port <portlist>]
The
default snmp trap link-status
command is executed in the
Interface Configuration command mode.
Table 29 "default snmp trap link-status command parameters and variables"
(page 69)
describes the parameters and variables for the
no snmp trap
link-status
command.
Table 29
default snmp trap link-status command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the port numbers on which to disable the
linkUp/linkDown traps. Enter the port numbers or all.
ATTENTION
If you omit this parameter, the system uses the port
number specified with the
interface
command.
CLI commands specific to SNMPv3
This section describes the unique CLI commands for configuring SNMPv3.
For details about the CLI commands that are common to both SNMP and
SNMPv3, see
"Common SNMP and SNMPv3 CLI commands" (page 58)
.
The following SNMP commands are specific to SNMPv3:
•
"snmp-server user command" (page 70)
•
"no snmp-server user command" (page 72)
•
"snmp-server view command" (page 73)
•
"no snmp-server view command" (page 74)
•
"snmp-server host for new-style table command" (page 75)
•
"no snmp-server host for new-style table command" (page 76)
•
"default snmp-server host command" (page 76)
•
"snmp-server community command" (page 77)
•
"snmp-server bootstrap command" (page 79)
Nortel Ethernet Routing Switch 2500 Series
Security — Configuration and Management
NN47215-505 (323165-B)
02.01
Standard
4.1
19 November 2007
Copyright © 2007, Nortel Networks
.
Summary of Contents for 2526T
Page 227: ......
