Nordson 107 041A, Manual

Page: 78 / 166

Operation
4-16
E
1996 Nordson Corporation
All rights reserved
107 041A
Issued 1/96
Manual 12-28
4. Touch the PRD WIDTH pad. Touch ENTER to calibrate the conveyor.
Follow the message prompts on the SET-UP SCREEN menu.
NOTE: Conveyor width selections are between 50.8 mm and 406.4
mm (2- to 16-in.).
5. Touch the digit pads to enter a desired conveyor width. Touch
ENTER.
NOTE: Always set the conveyor speed before setting the zone power
levels.
6. Touch the CONVEYOR pad. Touch ENTER. Follow the message
prompts on the SET-UP SCREEN menu.
NOTE: Conveyor speed selections are between 30 to 200 cm/min
(11.8- to 78-in/min).
7. Touch the digit pads to enter the desired conveyor speed from Touch
ENTER.
8. Touch the NITROGEN pad and toggle the ON/OFF pad to off, if
necessary.
Only the top oven zone temperatures are programmed. After a few
seconds of oven operation, temperature values appear in the
SET-UP
SCREEN menu’s actual column. All actual bottom zone temperatures
transfer over to the set point column when the profile is saved in the
library.
Perform the following to program the profiles zone temperature into the
oven:
NOTE: When the SETPT menu item is highlighted, the message area
displays the current top and bottom wattage ratio for that oven zone.
1. Touch the SETPT pad in the TEMP (C) column of the desired top
zone row. The zone temperature highlights.
2. Touch the digit pads to enter a zone temperature from 50
_
C to
325
_
C. The new zone temperature displays in the highlighted area.
3. Repeat steps 1 and 2 for the desired top zone temperature of each
remaining zone. A 0
_
C or a blank set point temperature entry
displays as dashes (– – –) in the SETPT column.
4. After a few seconds, oven temperature and wattage values in the
actual columns for each zone change. Alarm light stack color
changes to orange.
Setting Up the Oven
Conveyor
(contd)
Setting Oven Temperature