24
NOTE: If the tube refuses to stay on the sensor apply a piece of tape to
hold it in place.
6.
Aim the sensor perpendicular to the ground. Tighten all the sensor bracket
bolts.
7.
Use a square to adjust the target rod perpendicular to the sensor and to the
boom. The target should be directly under the center of the sensor. Tighten the
ball mount about a half turn past snug.
8.
Check that all the mounting bolts are tight and the dimensional requirements
are satisfied.
9.
After securing the mounting, any excess tube from the mounting bracket and
excess length on the mounting bolts can be cut off.
10.
The target rod can also be shortened. The target must extend at least 2" past
the center of the sensor.
11.
After all procedures are complete, check all dimensional requirements and
tightness of bolts again. If necessary, repeat
STEP 3
through
8
.
IMPORTANT:
Remove the tube alignment fixture (Item M14) after completing main
roll sensor installation.
Summary of Contents for UC4 Total Control
