23
The following
Figure 19
and
Figure 20
show a convenient location for mounting
the roll sensor on a Rogator Sprayer. It is located on the main section by the left
boom’s tire.
Figure 19 – Rogator Roll Sensor Mounting
Figure 20 – Rogator Roll Target Mounting
3.
Mount the sensor and target loosely in place. The sensor should hang vertically
without any stress because the sensor direction is critical. To avoid the stress,
cable-tie (
Items M2/M3
) the cable from the sensor (and the sensor branch cable
(
Item C2
)) to the mounting bracket tube or insert them into the tube.
4.
Adjust the sensor bracket to achieve the dimensional requirements in
Figure 14
and
Figure 15
.
5.
Place the tube alignment fixture (
Item M14
) on the sensor. Slide the tube over
the sensor up to its cable.
Sensor
Bracket
Main
Sensor
Target Bracket
Sensor Bracket
Target Bracket
Summary of Contents for UC4 Total Control
