26
Figure 22 – Valve Block Port Assembly
IMPORTANT:
Check the engraved part number on the top plate of the solenoid valves
(Figure 22). If the number is “105723”, proceed to STEP 13 (page 27). STEP
6 through STEP 12 are required for all other part numbers.
6.
Assemble the Single Acting Sandwich Block Kit (
Item H53
). Remove the 2
solenoid valves from the top of the valve block by removing the 4 Hex socket cap
screws from each valve and discard these 2-in long bolts (
Figure 23
).
7.
Coat the top and bottom of the sandwich block in clean hydraulic oil.
8.
Install the 4 O-rings into the bottom of the sandwich block.
9.
Place the sandwich onto the valve block with the O-rings facing downward.
10.
Align the sandwich with the alignment holes. The “A” stamped into the
sandwich faces the port side of the valve block (
Figure 23
).
11.
Place the solenoid valves on top of each sandwich and install the 2-1/2" long bolts
supplied with the sandwich.
12.
Tighten the bolts in a corner to corner pattern to 31 in-lbs. Finish tightening the
bolts in a circular pattern and torque the bolts to 62 in-lbs.
Summary of Contents for UC4 Total Control
