32
Figure 29 – Cable Configurations: C1 – C4
18.
Connect the 6-pin Tower on the UC4 Valve Cable (
Item C3
) to the mating 6-pin
Shroud on
C4
at the rear of the sprayer and route to where the NORAC valve is
located (
Figure 29
).
19.
Install
C3
onto each NORAC
valve as shown in
Figure 30
.
The connectors on
C3
are
marked
RIGHT UP, LEFT UP,
RIGHT PORT
(“right down”)
,
and
LEFT PORT
(“left down”)
.
Fasten with the included rubber
seals and screws. Ensure that
the cables are oriented as
shown, with the cable labels
RIGHT PORT
and
LEFT
PORT
on the SAME side as the
hydraulic hoses (the “port-side”
of the block).
Figure 30 – Valve Cable connections
20.
Connect the sensor branch cable (
Item C2
) to the 4-pin AMP plug on
C1
(
Figure 29
).
21.
If not done already, route
C2
out to the wing and main sensors. Connect them
using the 4-pin AMP connectors. Follow existing cables and/or hydraulic lines
along the boom.
Summary of Contents for SPRA-COUPE 7000 Series
