Norac SPRA-COUPE 7000 Series, Installation Manual, Page: 32 / 42

30
Figure 27 – Cable Configurations: C10A, C10B, C1, C4 and C11
7. Connect the 2-pin Shroud (black end, “Bypass Shroud”) on C11 to the 2-pin
Tower on C10 B .
NOTE: It may be easier installing the cables first, while installing the
grommet (M15) later.
8. Route C1 through the grommet. Then route the valve extension cable ( Item C4 )
unpinned end through the grommet as well.
NOTE: The valve extension cable ( C4 ) is packaged with one GP end not
installed. This is normal; it helps installations for these sprayer
types. Pin this connector on (connector included) as per drawing
in Section 5.4. TAKE EXTRA CARE! These pins require a special
tool to remove them if you make an error!
9. Connect 6-pin Shroud on C4 to the mating 6-pin Tower on C10 B .
10. Disconnect C10 A from C10 B at the 4-pin Sense Line connectors ( Figure 27 ).
11. Find the Spra Coupe joystick wiring harness located in the driver’s seat right-
hand armrest. It will have four grey 24-pin square Deutsch connectors.
Disconnect these connectors from each other, carefully noting their “mates”.
NOTE: Write down the wire colors and which connectors lead up to the
joystick before disconnecting.