Norac SPRA-COUPE 7000 Series, Installation Manual, Page: 16 / 42

14
preferred mounting will be less likely to damage the bracket in the event of a
boom contacting a post or obstruction.
5. The sensor cable should be run down through the tube of the mounting bracket
and then behind the member the bracket is mounted onto. Cable-tie (
Items M3
and/or M2 ) the connector in place. The cable must not be allowed to hang below
the boom ( Figure 8 ).
Figure 7 – Sensor Mounting (Preferred)
Figure 8 – Another Acceptable Mounting
Preferred mounting locations for UC4 sensors on the Spra-Coupe 7000 Series are
illustrated below:
FRONT