24
Figure 20 – Valve Block Port Assembly
6.
Mount the NORAC valve (
Item V1
) on the sprayer. The recommended location
for the valve is on the rear of the boom main section on the horizontal cross
member, above the Spra-Coupe valve block. Orient the valve block so the
NORAC block pressure and tank lines are on the same side as the Spra-Coupe
pressure and tank lines.
NOTE: You must ensure the valve manifold, solenoids, and hoses will not
interfere with any moving parts of the sprayer. Also, you must
ensure proper routing of the hoses such that they will not be
pulled tight at any time.
7.
Mount the valve using the mounting flat, bolts, and lock washers (
Item B10,
Item M11,
and
Item M12
) to bolt around the square tube on the sprayer
(
Figure 21
and
Figure 22
). The bolts should thread into the valve block at
least 3/8". The valve mounting holes are drill and tap 3/8 NC-1" Deep.
Summary of Contents for SPRA-COUPE 7000 Series
