A
CCESS
G
ATEWAY
System Administration
119
2.
System administrators can set the properties for each room from the subscriber side of the Access
Gateway. The system automatically detects which port number the administrator is using and allows
them to enter the fields for the room corresponding to the port they are using.
If required, click on the check box for
In Room Port Mapping
to enable this feature.
3.
If you enabled
In Room Port Mapping
, you must assign a
Username
and
Password
. You will need
these when you perform port mapping from the subscriber side of the Access Gateway.
Go to
on page 120
to map rooms from the subscriber side of the Access
Gateway.
For security reasons, this feature should be disabled when in room port mapping (from
the subscriber side of the Access Gateway) is completed.
4.
Select
No Port Location Mapping
if you are not using Port-based access.
5.
If VLANs are used on the network, and if desired, select VLAN IDs:
802.1Q two-way
.
6.
If you are using an access concentration device that cannot handle VLAN IDs, select one of the
available
Access Concentrator Query
options:
The devices in the following list must be assigned an IP address on the same subnet as
the Access Gateway. You must remove “old” concentrator types before entering new ones.
•
Tut Systems Expresso
•
Lucent DSL Terminator
•
Tut MDU Lite Systems
Summary of Contents for AG 2300
Page 1: ......