Nokia 500i, Installation Manual

Page: 49 / 80

Installing an Encryption Accelerator Card
Nokia 500i Installation Guide 49
5.
Position the three male PMC connectors on the card over the three female
PMC connectors on the motherboard.
The two sets of connectors should be aligned with each other. The four
screw holes and four standoffs should also be aligned with each other.
6.
Push down on the card until it is properly seated on the motherboard.
7.
Place the screws through the standoff holes on the card and into the
standoffs on the motherboard.
8. Turn each screw clockwise to attach the card to the standoffs.
Make sure that all four standoff connections are properly aligned before
tightening the screws completely.
9.
To secure the connections, tighten the screws firmly, but do not
overtighten.
10. Slide the chassis assembly back into the appliance and resecure the four
retaining screws.
Reseating the chassis assembly automatically restores power to the
appliance.
The accelerator card is automatically detected and enabled by default.
Screw
Accelerator card
Standoff hole
Motherboard standoff