Nodal Ninja Fanotec MECHA, User Manual, Page: 104 / 109

104
MECHA User’s Guide v.05.4
© 2020 FANOTEC
123<
Shows the en�re MAC address like '123ABC123ABC'.
323<
Shows the Full IP address like '192.168.0.100'. To avoid confusion, the IP
address is shown only once, then it automa�cally exits from IP address
display.
321<
Shows the Last part of the IP address, star�ng with dot, like '.100'.
If '
AAA ' is shown, MECHA is in AP mode, and the IP address is
192.168.8.1
If
!!! is shown, Wi-Fi is OFF.
If either ' .0 ' or ' 0.0.0.0 ' is shown, MECHA isn't in AP mode, nor does it
have an IP assigned. In which case, a re-start, then bu�on [1] pressed 3
seconds at -=-=-= (spli�ng lights) will enable AP mode, and will allow to
access the web interface through 192.168.8.1
13<
Shows the Ba�ery percentage.
131313<
Reboot MECHA without power cycling it.
This is useful when you want MECHA to reboot (say, to enable Wi-Fi, or
change the AP-STA mode, or re/un/pairing), without disengaging the
motors. Thus, the camera will not move due to gravity, or other causes.
21<
Switches MECHA to or off pause mode, the same as clicking the [PAUSE]
bu�on on UI, or on IR Remote.
23<
Disables/Enables the motor.
UI
[Reboot] command will be ignored if the motor is disabled.
When motor is disabled, the power LED will blink rarely, it blinks also in
UI , and in UI "(o)" will be shown on top, for now.
This is useful to prevent MECHA turning on by accident while charging,
for kids protec�on, or to simulate the use for learning purpose, saves
energy and the ba�ery can be charged faster.
There are other applica�ons, not listed here.