Nlynx OmniTerm WBT, User Manual

Page: 66 / 131

Terminal Properties
MicroTouch Panel:
This device is used to setup a Touchscreen panel (Micro Touch only).
Note: All connections should be done while power is off on the base and
monitor.
The Micro Touch Panel monitor you received should have had three cable
connections. One for line voltage, one SVGA video connection and a DB9
female serial connection. The serial cable should be connected to the DB9 male
COM port on the back of the OmniTerm terminal.
To configure, from the terminal manager screen press F2, click on the
"Devices" Tab then Double click on the Micro Touch icon.
Hardware:
Information
Status should be OK. If Status = NOT FOUND, press Find touchscreen .
Connection
Set serial port and Baud Rate. (This is normally not necessary)
Press
Find touchscreen if Status = NOT FOUND.
If NOT FOUND status persists, the Serial cable may not be connected or there
is a problem with the MicroTouch panel.
63