SR Troubleshooting
Turn on the power while pressing [Enter|Pause].
nds.
Press and hold the switch until the buzzer sou
You can release the switch when the buzzer sounds.
（
Be sure that the Buzzer is not OFF.
）
1. How to Set the Threshold Value
Remedies for the Label Error
Please turn off the power first.
on.
Then set the labels and ink ribb
About three labels are fed, the buzzer sounds at the intervals of one
second, and the Ready LED flashes to indicate that the threshold
value is set successfully.
Turn off the power.
The buzzer sounds continuously when the threshold value setting
fails. In this case, start over again from setting the labels and
the ribbon.
Check whether the printer works normally. Are labels printed correctly?
One Point Lesson
Note!!
Printer
Control Panel
What is the threshold value setting?
label exists, the sensor measures the
st
To make a judgment whether the
amount of light that passes through label and that which passes through
the backing paper. The values are saved in the printer automatically.
Therefore, each time you change the label, the threshold value for it mu
be set.
We suggest you practice this operation each time you replace the labels.
2
