SR Troubleshooting
1. How to Adjust the Function Setting No. 1
C
Note: When the function setting is sent to the
printer by printing software you generated,
the sent setting is effective.
Turn the printer off and turn the density switch
C
to 1. Turn on the power while pressing
F
[Mode/Reset] (See the figure on the right.).
Press and hold the switch until the buzzer
sounds (Release the switch when the buzzer
sounds.).
Check to see that
A
[Ready] LED
flashes.
(
The flashing of [Ready] LED shows that
the printer is in the function setting mode.
)
What is the number of the lit lamp in
B
?
(
If two
lamps are lit, the sum of the numbers on the left
of the LEDs is the value of setting 1.
)
Is the
value 6 or 7? 6 or 7 means automatic model is
mounted, and in this case you can’t print labels
without a command from outside such as that
from a sequencer. In this case,
select 1
(standard model) with
↑↓
in
E
and press and
hold
D
[Enter/Pause] at least 2 seconds.
(
The
buzzer makes a series of beeps.
)
Press and hold
F
[Mode/Reset] at least 2 seconds. Turn the
power off and reset the density switch.
F
E
D
B
A
Buzzer switch
must be at L or H.
24