SR Troubleshooting
2. How to Modify the Setting of Function No.10
Check the ink ribbon you use. The type of the ink ribbon we produce and the
corresponding setting of function No. 10 are shown in the table below.
11
Ink Type
G PN
DLH
H(label PT)
PO
H(label PH)
DWH
Setting of function
NO.10 (Supply)
1 1
5
9
8
Buzzer switch
must be at L or H.
Turn the printer off and set the density switch
C
to
10. T
on the power while pressing
F
urn
to see that
[Mode/Reset] (See the figure on the right.). Press
and hold the switch until the buzzer sounds
(Release the switch when the buzzer sounds.).
Check
A
[Ready] LED flashes (The
ows that the printer is in
What
is the number o
flashing of [Ready] LED sh
the function setting mode.).
f
the lit LED in
B
? (If two LEDs are lit, the sum of
the numbers on the left of the LEDs is the value of
setting 10.)
number with
When the value for your ink and that
of function setting 10 is different,
select the right
↑ ↓
in
E
and press and hold
D
[Enter/Pause] at least for two seconds
(The buzzer
series of beeps.). Press and hold
F
[Mode/Reset] at least for two seconds. Turn the
power off and reset the density switch.
makes a
Note: When the function setting is sent to the
printer by printing software you generated,
the sent setting is effective.
A
B
C
D
E
F