SR Troubleshooting
1.3. The Width of the Backing Paper
and that of the Ink Ribbon
1.2. The Influence of Ejected Paper
15
Turn off the power.
→
Open the cover.
As is shown in the figure on the previous page, set the end of
the backing paper in parallel with the edge of the center
sensor and set the label guides. Adjust the position of the roll
holder so that the labels go straight in the feeding direction.
When the backing paper with a lot of
printed labels falls down slanting as
is shown in the upper figure on the
right, next label are likely to be
pulled leftward and as a result the
position of the printed data deviates
rightward.
Be sure that the backing paper falls
in a direction perpendicular to the
output slot.
The width of the ink ribbon should be
wider than that of the backing paper of
the labels by 5mm on both sides (See
figure on the right).
When the ribbon is as wide as, or far
wider than, the backing paper, a
blurred print or creased ribbon may
occur.
