www.nitronic.ch
-
22 -
Nitronic AG
Mattenstrasse 11
CH – 2555 Bruegg
Tel.
+41 32 373 7070
Switzerland
Fax
+41 32 373 70
75
Set the piece counter to
0
before processing starts.
Program Step
Selecting
and Entering
Select the Del Counter
F – Del Counter
6. Memory access locking code (Code)
Any set parameters programmed into the ST730
T
can be protected by entering a 3-digit freely
selectable locking code.
Make sure to write down the code! Otherwise, access to the memory is no longer possible.
Program Step
Selecting
and Entering
Enter a code number, e.g. 1 2 3.
At the top of the display is shown the Code
Symbol.
By entering this code e.g. 1 2 3, access to the
Memory is again enabled.
F – Code –
1 –
2
–
3
- Enter
F – Code –
1 –
2
–
3
- Enter
After the code has been entered the following activities can be selected only:
Select Cable ¦ Select Step ¦ Select Quantity
In case of forgotten or misplaced code, the memory can only be accessed with a classified code.
This code can be obtained by the manufacturer or your local service partner.
7. Joining of multiple programs (Sequence)
If a cable needs different stripping lengths on either end than working with multiple programs is
required. For this purpose with the „Sequence“ function an arbitrary number of programs can
combined into a single sequence and processed one after the other.
