www.nitronic.ch
-
16 -
Nitronic AG
Mattenstrasse 11
CH – 2555 Bruegg
Tel.
+41 32 373 7070
Switzerland
Fax
+41 32 373 70
75
5. Step 0
Programming:
To optimize the stripping time use
Step 0
to enter the outside diameter of the wire.
After starting the stripping cycle, the stripping blades immediately close to the selected outside
diameter before they start cutting with the programmed feed rate.
Program Step
Selecting
and Entering
Choose the preset diameter (
∅
∅
∅
∅
3.00
)
and enter the cable outside diameter
+0.5mm e.g. 6.50 mm.
3.00 –
6.5
- Enter
d
D
At missing entry of Step 0:
In case
Step 0
is not programmed the control uses the largest diam-
eter stored in the current program. In this example the diameter in
Step 3
is the largest one stored
in the memory. This avoids the blades do not close with a high feed rate through the different lay-
ers.
Rule:
The diameter in
Step 0
can never be smaller than the largest diameter determined in the
current program.
4. Step 1
Program Step
Selecting
and Entering
Choose the preset diameter
(
∅
∅
∅
∅
1.00
)
and enter the cable diameter e.g. 0.90mm
Choose the preset stripping length
(3.0)
and enter the stripping length e.g. 6.0mm.
1.00 –
0.9
– Enter
3
3.0 –
6
– Enter
Avoid damaging of the cable:
select during programming a slightly larger strip-
ping diameter and correct it downward after the stripping test.
5. Step 2
Program Step
Selecting
and Entering
Choose the preset diameter
(
∅
∅
∅
∅
2.00
)
and enter the cable diameter e.g. 3.65mm
Choose the preset stripping length (
6.0
) and
enter the stripping length e.g. 16.0mm.
1.90 –
3.65
– Enter
9.0 -
16
– Enter
