233
Service Manual – SW5500, FLOORTEC R 985
43 - Sweep System, Side Broom
Side broom height check and adjustment (continues)
3 For the right side broom, regulate by loosening the ring nut (C) and by adjusting the adjuster (D) until
the correct print (A) is achieved Finally lock the adjuster (D) into position with the ring nut (C)
For the left side broom, operate on the adjuster by loosening the ring nut (E) and by adjusting the
adjuster (F) until the correct print (B) is achieved Finally lock the adjuster (F) into position with the
ring nut (E)
4 Perform step 1 again to check the proper adjustment of the side broom height
5 When the broom is too worn to be adjusted, replace it (see
in the relevant paragraph)
6 If necessary, adjust the side broom height, according to the following procedure
Tilting Adjustment
7 Loosen the screws (G) fastening the side broom motor (H) and adjust the inclination
When the adjustment is completed, tighten the screws (G)
Figure 5:
D
A
B
C
E
F
G
H
