177
Service Manual – SW5500, FLOORTEC R 985
29 - Engine System, LPG
Fuel Solenoid Valve Filter Cleaning (Continues)
4
Remove the filter (E).
The filter holder gasket (F) must be replaced with the corresponding spare part, before reassembly.
5
Remove and discard the gaskets (F) and (G), then clean the filter (E), the flange (H) of the fuel solenoid
valve body, the filter holder (I) and the fitting (J) with compressed air (maximum pressure 6 Bar). Clean
the filter (E); replace if necessary.
Take care in order not to damage the remaining part of the fuel solenoid valve; do not sink the coil in
solvent or water
Assembly
6 Assemble the components in the reverse order of disassembly, and note the following:
◦ On the fuel solenoid valve, tighten the fitting (J) to a tightening torque of approximately 16.6 Nm
(147 lb-in)
7 Check the LPG system for leaks (see
in the relevant paragraph)
Figure 12:
J
I
I
G
F
E
F
H
