www.usmotors.com
ID300/302 Integrated Motor Drive |
Start Up Tips for the ID300/302
7
1.7 Drive Functions
The
0 Menu
has been customized to allow easy access to most of the parameters that are commonly
changed by a user.
0 Menu
will be different in your unit versus the factory reset values stored in the
ID300/302.
With the
RTC keypad cable
already connected to the
RJ45 plug
inside the ID300 and the
jumper wire
installed from
Terminal 6 to 8
, follow the steps below to change any parameter value in the ID300/302:
1. Power up the unit.
The keypad will light up and display “READY”.
2. Press the
Enter
button to access
Programming Mode
.
The display will change to show a menu and parameter value.
3.
Press the arrow keys to navigate to a specific parameter menu (from 0 – 22).
The Left and Right arrow key decrease and increase the menu number respectively.
4.
In the specific menu, press the
Up
and
Down
arrow keys to reach the exact parameter.
5. Press the
Enter
button.
The right-most digit will begin flashing.
Button
Function
The
Green
button starts the motor.
The
Red
button stops the motor.
The arrows buttons to navigate the menu system and change the settings
once the parameter is selected.
The
Enter
button selects
Parameter View or Edit Mode
. It also saves a
parameter change.
When navigating in
Parameter View
to a specific value, press the
Enter
button to begin editing.
Use the arrow keys to change the parameter value. Then, press the
Enter
button again to accept the change.
Used the
Escape
button to exit from the
Edit
Mode
. Press this button to
return to the Main Screen.
The Main Screen is used to adjust the speed of the motor. The motor
input frequency can be changed using the arrow keys. Since the ID300 is
an asynchronous motor, it will operate at an RPM related to the frequency
setting, less the motor slip.
