2
Installation and quick start commissioning guide - Commander ID300/302
5511 en - 2017.06 / a
NOTE
LEROY-SOMER reserves the right to modify the characteristics of its products at any time in order to incorporate
the latest technological developments. The information contained in this document may therefore be changed
without notice.
WARNING
For the user’s own safety, the Commander ID300/302 must be connected to an approved earth ( terminal
).
If accidentally starting the installation is likely to cause a risk to personnel or the machines being driven, it is
essential to supply the equipment via a circuit-breaking device (power contactor) which can be controlled via an
external safety system (emergency stop, detection of errors on the installation).
The Commander ID300/302 is fitted with safety devices which, in the event of a problem, control stopping and thus
stop the motor. The motor itself can become jammed for mechanical reasons. Voltage fluctuations, and in particular
power cuts, may also cause the motor to stop. The removal of the causes of the shutdown can lead to restarting,
which may be dangerous for certain machines or installations.
In such cases, it is essential that the user takes appropriate precautions against the motor restarting after an
unscheduled stop.
The variable speed drive is designed to be able to supply the motor and the driven machine above its rated speed.
If the motor or the machine are not mechanically designed to withstand such speeds, the user may be exposed to
serious danger resulting from their mechanical deterioration. Before programming a high speed, it is important that
the user checks that the installation can withstand it.
The Commander ID300/302 which is the subject of this manual is designed to be integrated in an installation
or an electrical machine, and can under no circumstances be considered to be a safety device. With the sole
exception of the Safe Torque Off (Commander ID302 only), none of the drive functions must be used to ensure
safety of personnel, i.e. they must not be used for safety-related functions. It is therefore the responsibility of the
machine manufacturer, the designer of the installation or the user to take all necessary precautions to ensure that
the system complies with current standards, and to provide any devices required to ensure the safety of equipment
and personnel.
LEROY-SOMER declines all responsibility in the event of the above recommendations not being observed.
........................................
Manual corresponding to drive versions higher than or equal to firmware V03.00.00.06 and to power
V03.00.00.04.
This manual only describes the characteristics, the installation and the quick start of the Commander ID300/302,
associated to Leroy-Somer motors (with or without brake).
For more information about the Commander ID300/302, please use the web address:
www.commanderID300.info.
For additional information about IMfinity motors, geared motors or FFB brake, please refer to the
documentation available on www.leroy-somer.com.
