Nice Moon MC824H, Functions

Page: 11 / 153

Apartment block 2 step step
Hold-to-run
Industrial mode
This executes the sequence “ Partial open - Partial open ”
through to the position programmed in the “Partial open” func-
tion; if another command is sent after reaching this position,
the control unit activates a closing manoeuvre.
Important - If
the command sent remains active for more than 2 seconds,
the control unit activates a stop command.
The “Partial Open” or “Closing” manoeuvre is executed exclu-
sively if the hold-to-run command is used.
This executes the sequence “ open in semi-automatic –
close in hold-to-run ”.
OPERATING MODE
Open - Stop - Open
Apartment block 1
Apartment block 2
Hold-to-run Open
Industrial mode
DESCRIPTION
Operating mode set in factory (Input 2 - “open” com-
mand).
This executes the above sequence.
This executes the sequence “ open- open ”.
This executes the sequence “ open- open ”. Important - If the
command sent remains active for more than 2 seconds, the
control unit activates a stop command.
The Opening manoeuvre is executed exclusively if the sent
command persists (hold-to-run).
This executes the sequence “open in semi-automatic – close
in hold-to-run”.
In this command category the user can select one of the operating modes specified in Table 1-C.
TABLE 1-C : COMMAND CONFIGURATION
Open
OPERATING MODE
Close - stop - close
Apartment block 1 close
Apartment block 2 close
Hold-to-run close
Industrial mode
DESCRIPTION
Operating mode set in factory (Input 3 - “close” com-
mand).
This executes the above sequence.
This executes the sequence “ close-close ”.
This executes the sequence “close-close”. Important – When
sending a command, if the latter remains active for more than
2 seconds, the control unit activates a Stop.
The Closing manoeuvre is executed exclusively if the sent
com mand persists (hold-to-run).
This executes the sequence “ open in semi-automatic – clo -
se in hold-to-run ”.
In this command category the user can select one of the operating modes specified in Table 1-D .
TABLE 1-D : COMMAND CONFIGURATION
Close
OPERATING MODE
Halt
Halt and brief inversion
DESCRIPTION
When this type of function is set, when the control unit re -
ceives the command, it stops the Opening manoeuvre in
progress immediately.
Operating mode set in factory. When the control unit re -
ceives the command, it stops the Opening manoeuvre in pro -
gress immediately and activates the application to perform a
brief inversion in the opposite direction (Closing).
In this command category the user can select one of the operating modes specified in Table 1-E .
TABLE 1-E : COMMAND CONFIGURATION
Halt on opening
Intelligent Security & Fire Ltd.