NF ZA57630, Instruction Manual

Page: 195 / 246

5.5 Measurement Connector
s (Measurement Mode IMPD−2T)
5
-
11
ZA57630
5.5 Measurement Connectors (Measurement Mode IMPD
−2T)
5.5.1 Front Panel PORT3
An AC signal for measurement and a DC bias can be output as signals for measurement.
The AC signal for measurement is output from the front panel
PORT3
connector.
There are the two types of DC bias, the normal DC bias and HV DC bias, and the selected
type can be used.
The normal DC bias and HV DC bias are output from the front panel
PORT3
connector. (The
normal DC bias and HV DC bias cannot be output from the rear panel
DC BIAS OUT
connector.)
A signal with the AC signal and DC bias composited is output from the front panel
PORT3
connector.
Unless otherwise specified, the measurement signal amplitude is set as a voltage and ALC is
OFF.
・
Connector N connector (front panel
PORT3
)
・
Frequency
Setting range 10 µHz to 36 MHz (when HV DC bias is off)
1 kHz to 36 MHz (when HV DC bias is on)
Setting resolution 10 µHz
Accuracy (Common to "
・
Frequency" in "
5.3.1 Front Panel H
CUR
/OSC
")
・
Measurement signal amplitude
Setting range
Voltage 0 to 3.00 Vrms
There is a following restriction between the measurement signal
amplitude setting and normal DC bias setting.
(Measurement signal amplitude setting [Vrms] × 1.42) + |Normal DC bias
setting [V]| ≤ 5.0
There is a following restriction between the measurement signal
amplitude setting and HV DC bias setting.
(Measurement signal amplitude setting [Vrms] × 1.42) + |HV DC bias setting
[V]| ≤ 42.0
Current 0 to 60 mArms
The setting range is limited because it is dependent on the
measurement range, etc.
There is a following restriction between the measurement signal
amplitude setting and normal DC bias setting.
(Measurement signal amplitude setting [Arms] × 71) + |Normal DC bias setting
[A] × 50| ≤ 5.0