NF FRA5022, Instruction Manual

Page: 116 / 145

5.6 Status System
FRA5022
5-38
Table 5-5 Operation condition register contents
Bit Weight Contents (when standard status 1)
SPOT 12 4096 During spot measurement
Single: At each measurement, set to 1 when the measurement
starts, and cleared to 0 when the measurement ends.
Repeat: Remains 1 during a repeat measurement.
Not cleared to 0 at each measurement.
MSW 11 2048 In manual sweep measurement: running measurement at one
point
ASW 10 1024 Running automatic sweep measurement
HOLD 9 512 Hold state
SLOW 8 256 Changing output voltage SLOW
CAL 0 1 Running self calibration
Other
－ －
Always at 0 (unused)
■
Related commands / queries
STATus:OPERation:CONDition?
Queries the operation condition register contents.
The condition register content is not cleared to 0 even if queried.
Always indicates the status of
FRA5022
.
STATus:OPERation:NTRansition / STATus:OPERation:NTRansition?
Sets/queries the negative transition filter register.
STATus:OPERation:PTRansition / STATus:OPERation:PTRansition?
Sets/queries the positive transition filter register.
Set to 0 to clear these filter registers to 0.
Cannot be cleared by any other command.
Cleared to 0 upon powering on.
STATus:OPERation[:EVENt]?
Queries operation event register.
The event register is cleared to 0 if queried.
The event register can also be cleared with a
*
CLS command.
Cleared to 0 upon powering on.
STATus:OPERation:ENABle / STATus:OPERation:ENABle?
Sets/queries the operation event enable register.
Set to 0 to clear the enable register to 0.
Cannot be cleared by any other commnad.
Cleared to 0 upon powering on.
A parameter of each register setting message or response message takes a value that adds
up the weight of all bits set to 1.