PARTS:
• • 8 x M8 T-Nuts
PARTS:
• • Mounting Arms
• • 8 x M8 16mm Bolts
• • 8 x M8 Washers
• • 4 x Sticky Felt Pads
(90mm x 10mm)
PARTS:
• • Front Mount Bracket
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
PARTS:
• • 4 x M8 25mm Low Profile Bolts
• • 4 x M8 Nylon Washers
• • 4 x M8 Flange Nuts
PARTS:
• • NIL
PARTS:
• • 2 x Seat Slider Ratchet Handles
18
19
Video Instruction: bit.ly/nlrbuild
25
30
Loosen the Bolts securing the Side Mount Brackets to the Front Mount Brackets. Adjust the Wheel
Base to the desired angle and tighten the Bolts to lock in place.
29
Align the Wheel Base Assembly with the slots on the Mounting Arms. Bolt through and secure with
4 x M8 Low Profile Bolts, Nylon Washers and Flange Nuts.
26
Install 2 x T-Nuts into the front channel and 2 x T-Nuts into the rear channel of the Left Wheel Post.
Repeat for the Right Wheel Post.
27
A) Install Felt Pads to the Mounting Arms to avoid scratching of Wheel Post when adjusting the height of the wheel.
B) Align the holes on the right Mounting Arm with the T-Nuts previously installed in
Step 26
. Bolt through and secure with 4 x
M8 Bolts and Washers. Repeat on the other side.
Felt Pads
28
A) Align the slots on the Front Mount Bracket with the mounting holes on your Front Mount Wheel Base.
B) Bolt through and secure with 4 x M8 Bolts and Washers
.
A) Align the rear Seat Slider assembly with the T-Nuts previously installed in
Step 01a
&
Step 01b
.
B) Bolt through and secure with 2 x Ratchet Handles.
FRONT MOUNT ANGLE ADJUSTMENT
A
)
B
)
Repeat
on Other
Side
A
)
B
)
Note:
Use level provided to ensure
the Wheel Assembly is kept flat during
installation to avoid skewing.
Note:
Use level provided to ensure
the Wheel Assembly is kept flat during
installation to avoid skewing.
Repeat
on Other
Side
FRONT MOUNT ASSEMBLY
A
)
B
)
