Video Instruction: bit.ly/nlrbuild
8
9
01a
Slide 8 x T-Nuts into the outside channels of the Left Base.
IMPORTANT:
Place T-Nuts as shown in diagram below on the
OUTSIDE
of the Left Base.
(Red dots are T-Nuts placement)
LEFT
RIGHT
REAR
FRONT
FRONT
REAR
ANGLE
HEIGHT
DISTANCE
Note:
Slide 2 x
T-Nuts to front for
Pedal Support
Note:
Slide 4 x
T-Nuts to middle for
Wheel Post
Note:
Slide 2 x
T-Nuts to rear for
Seat Sliders
Note:
For easier installation hand
screw M8 bolt into T-Nut to assist
sliding T-Nut into channel.
Install cable clips at the location you would like them
during the build. Leaving the installation of cable clips
to the end can present installation issues. Depress the
alignment tab at the back during installation.
• Please do not use power tools for assembly as over tightening can damage your frame.
• Please ensure T-Nuts are correctly placed within the extrusion.
• Lay out and build the cockpit on a level surface.
• Do not force parts together.
• Avoid cross threading bolts.
• If you require further support, consult the installation video or contact us at [email protected]
• The GTElite Lite is a two person build with the complete cockpit a two person move.
• Beware of sharp edges on the extrusion pieces.
ALUMINIUM EXTRUSION TIPS
