Nexcom NIO200 HAG, User Manual

Page: 54 / 120

NIO200 HAG User Guide Page 54 of 120
This section enables you to configure the Device Variables being published through the burst
message. We will be calling these Variables for simplicity.
To add a Variable to a burst message definition:
1. In an empty edit box, type the variable parameters in the order and format indicated in the
Help form: the device variable code (see Common Table 34 and device family codes), the
name on the v ariable to be displayed in the Readings page, the slot of device variable (value
in 0-7 range: 0-3 for command 33 and 0-7 for command 9), the device variable classification
(see Common Table 21 and Command 104; required for commands 3 and 33), the units code
(see Common Table 2 and Command 4; required for commands 3, 9 and 33),
The command number and burst message index are the same as those used in the burst
message definition and are not editable in the interface.
2. Click Save . The variable will be added to the variables list for that specific burst message and
the changes will be saved in the Monitoring Host configuration file.
To edit a variable:
1. In the variables list, click on the entry that you want to edit
2. Edit the desired parameters and click Save . The changes will be stored in the
Monitor_Host_Publishers.conf” file
To delete a variable:
1. Select a variable in the list and click Delete .
2. You will be asked for confirmation. Click Yes to delete the variable or Cancel to abort the
action.
After you perform any of the above operations, click Activate to load the changes into the Monitoring
Host.