Nexcom NIO200 HAG, User Manual

Page: 34 / 120

NIO200 HAG User Guide Page 34 of 120
To go to a specific command, select it from the Commands drop-down list. After you generate the
command, a message at the bottom of the screen will indicate its status (“Command sent
successfully”, “Command sent error”). The tracking number of the command is also indicated,
together with a link to the Commands Log, where you can view the results of the command.
Note: Currently only the WirelessHART general command is supported. Other commands may be
added in the future.
6.4.6.1 WH General Command
This set encompasses all the general commands that can be issued on the devices (e.g. 800 - read
service list, 782 - read session list, etc.). To generate the command, follow the steps described below:
1. Select the WH General Commands set from the Command drop -down list;
2. Optionally, select the BypassIOCache value:

Yes
– if you wish to retrieve the response to the command directly from the device ,



No
– if you wish to obtain the response from the Gateway cache,



If you do not select a value, the default value “No” will be considered ,


3. Type the command number in the CommandNo field,
4. For commands that have parameters, type the content of the request in the Command (hex)
field ,
Press Execute
. A message at the bottom of the screen will indicate the command status (“Command
sent successfully”, “Command sent error”). The tracking number of the command is also indicated,
together with a link to Commands Log, where you can view the response.