neuroConn DC-Stimulator, User Manual, Page: 50 / 85

Chapter 5 - Software Reference Manual
50
Enabling study mode
- Press button 2 or 4 to go to the main menu SYSTEM. Press button 3 to move the cursor
to line 2 on the display.
- Now keep pressing buttons 2 or 4 until you get to the submenu study mode. Press button
3 to move the cursor to line 4 on the display.
- Press button 2 or 4 to enable / disable the study mode. The display shows “save, please
wait”.
- Press button 1 several times to move the cursor back to line 1 (the main menu).
After enabling the study mode you have to reboot the DC- STIMULATOR (switch
off and switch on the device). Without reboot the study mode will not work
correctly.
Procedure of a study
After rebooting the system in active study mode the display indicates only the limited
selection of the settings (Figure 30).
Figure 30: Display in active study mode, limited selection
of settings
Figure 31: Display for entry of code for normal or sham
stimulation.
Use button 1 to switch between settings B, C and D. Press button 4 (OK) to confirm your
selection.
The system now requests a code for normal or sham stimulation (Figure 31).
Press button 1 repeatedly to insert the correct number. Move the cursor to the next digit by
pressing button 3. Insert the right number as described above.
Button 2 leads you back to the settings selection.
Now confirm the entered code with button 4 (OK). You will get to the main menu
STIMULATION and then can start/cancel the normal/sham stimulation as usual.