neuroConn DC-Stimulator, User Manual

Page: 46 / 85

Chapter 5 - Software Reference Manual
46
Load setting
In the so-called settings you can predefine sets of parameters (e. g. type of current, voltage,
duration etc.). 4 settings (A, B, C, D) can be saved. The settings are used in study mode
(see Software Reference Manual: Study mode).
First you need to load one of the 4 settings. Then you can change and save the stimulation
parameters in the loaded setting. To load a setting follow these instructions (Figure 27):
- Press button 2 or 4 to select main menu SYSTEM. Move the cursor to line 2 on the
display by pressing button 3.
- Switch to submenu load setting by pressing button 2 or 4 several times. Move the cursor
to line 4 on the display by pressing button 3.
- Select the setting (A, B, C, D) by pressing button 2 or 4.
- If you now use button 1 to move the cursor upwards, the display shows “load setting...”
and returns automatically to the main menu PARAMETER. There you define the
stimulation parameters (see Software Reference Manual: PARAMETER).
- Press buttons 1 and 3 simultaneously to save the changes in the setting. For a few
seconds the display shows "save setting A" (depending on choice B, C or D).
Figure 27: Main menu SYSTEM, submenau load setting
The stimulation parameters defined in the settings still remain active after
rebooting the DC-
STIMULATOR . Switching on the DC- STIMULATOR always
setting A (in study mode setting B) is the active setting.