Container Cleaning System TANKO®EX-R64T
7 Maintenance
Translation - Operating/installation instructions 2020/03
65/80
Point Inspection and maintenance work
Interval
Method
Initial check
Follow-up
check
A
Check the tightness of the thread and check the
functional reliability of the thread lock.
Restore safety
Check thread for wear and/or damage.
Replace device in the event of wear or damage
200 h
B
200 h
B
S/F/A
B
Check actuator/ball bearing area for functionality
(rotatability), contamination, wear and damage.
Clean in the event of contamination
Replace device in the event of wear or damage
200 h
B
50 h
B
R/S/F/A
C
Check tightness of thread and
check functional reliability of the thread lock.
Restore safety
Check thread for wear and/or damage.
Replace device in the event of wear or damage
200 h
B
200 h
B
S/F/A
Table 7.4-1: Inspection and maintenance work
7.4.2
Tools and Tightening Torques
Use only proper tools that are required for performing the required work and approved for use.
NOTE ON EXPLOSION PROTECTION
When working in areas where flammable or easily ignitable vapors, liquids or dusts are
present, where sparks could result in a potential fire or explosion hazard, tools that are
unlikely to create sparks should be used.
If this is not observed, the explosion protection could be disabled.
Do not use a tool that could create sparks.
When working in a potentially explosive atmosphere, it is important to remember that possible spark
formation is also influenced by factors other than the tool, e.g.:
–
the material to be processed,
–
the hardness of the material to be processed compared to the hardness of the tool,
–
the impact or friction energy applied
–
additional, existing deposits that could cause spark formation, such as rust, aluminum, combustible
dusts and the oxygen level.
The following tools/special tools are sufficient for mechanical work on the device:
–
Strap wrench/belt wrench (e.g. Ø 140) with fabric tape
The tightening torques must be selected according to the strength of the material and the
thread size of the pipe connection.
