Container Cleaning System TANKO®EX-R64T
44/80
Translation - Operating/installation instructions 2020/03
5 Installation
CAUTION
Fault as a result of soiling, foreign matter or damage to the device!
Foreign matter such as scale, burrs, chips, etc. can restrict the flow or enter the pipe
system and cause malfunctions or damage to components, including gaskets. That can
result in hazards that endanger the functional safety of the device.
There is a risk of minor or moderate injuries.
Before the device is installed for the first time and for assembly after conversion work on
the system in which the device is installed, the following measures must be taken.
Thoroughly rinse all supply and return lines of the cleaning medium with clear water in
order to remove any dirt, foreign matter or residues in the supply line (e.g. lime, chips,
welding particles, etc.).
Prevent dirt and foreign matter from entering the device through appropriate
measures. Install a filter upstream of the media connection [MA] in the cleaning media
supply line (see
Section 3.4 Cleaning Media
Do not apply any paint to the surface of the device.
Fastening the device to the container is the responsibility of the owner. The container connector
must be sealed reliably.
The use of insulating materials (such as Teflon tape or similar) for sealing is NOT permitted.
Please also note:
If the device is used outdoors or in rooms where there is a risk of frost, it must be protected against
freezing.
The pipe or hose connections and the cleaning media connection [MA] must be firmly fastened and
have a permanently tight design (hazard due to fluid being expelled in the event of leaks).
After installation, it must be ensured that all parts of the device have a conductive connection with
the container and are grounded (leak resistance to ground RE < 10
6
ohm).
5.2.1
Interfaces
1
2
3
