NETLink PRO ETH
31
RFC1006 parameters:
RFC1006 Interface
ON or OFF
The following parameters only have a
meaning if the RFC1006 interface is
switched on (ON).
- Bus autobaud
Determine bus parameters of the bus system
automatically (ON) or go online with the
stored parameters (OFF).
- Own station address
This is the address with which the NETLink
PRO ETH will participate in the bus cycle.
- Stored bus parameters
If autobaud is OFF, the bus parameters stated
here are used to go online.
- Rack/slot mode
Indicates whether R/S mode (ON) or
addressed mode (OFF) is used (for details,
see 8.1.4).
- Fixed destination
address for R/S mode
If R/S mode is activated, all incoming
RFC1006 requests are routed to the bus
address parameterized here.
Password settings:
New password
Password with up to eight characters
Retype new password
The password with up to eight characters must
be entered a second time
After you have entered changes, clicking the ‘
Cancel
’ button will discard
your changes again.
If you click the ‘
OK
’ button, the inputs are checked for plausibility. You
may then be shown which inputs are incorrect and what correct input would
look like at this point.
If all entries are consistent, the changes are displayed again as they will now
be stored in the NETLink PRO ETH when you click the ‘
OK
’ button again.
After the new parameterization data have been stored, the NETLink PRO
ETH is restarted to activate the new configuration.
It is also possible to reboot the NETLink PRO ETH remotely via the
configuration interface, if required. This is done by clicking the ‘
System
Reset
’ button.
7.4
Security-Page
The security page, accessible via a link on the home page, is a configuration
interface for all security specific settings.
Before this page opens, it is necessary to enter the device name (
NETLink
PRO ETH
) and the password (
admin
if no user specified password is stored).
i
Rebooting can take up to
15 seconds.
i
The default password is
‘admin’.
