Managed Switch CLI Manual, Release 8.0.3
Routing Commands
4-71
v1.0, July 2010
show ip ospf database
This command displays information about the link state database when OSPF is enabled. If you do
not enter any parameters, the command displays the LSA headers for all areas. Use the optional
<areaid>
parameter to display database information about a specific area. Use the optional
parameters to specify the type of link state advertisements to display.
Term
Definition
Type
The type of the route to the destination. It can be one of the following values:
intra — Intra-area route
inter — Inter-area route
Router ID
Router ID of the destination.
Cost
Cost of using this route.
Area ID
The area ID of the area from which this route is learned.
Next Hop
Next hop toward the destination.
Next Hop Intf
The outgoing router interface to use when forwarding traffic to the next hop.
Parameter
Description
asbr-summary
Use
asbr-summary
to show the autonomous system boundary router (ASBR) summary
LSAs.
external
Use
external
to display the external LSAs.
network
Use
network
to display the network LSAs.
nssa-external
Use
nssa-external
to display NSSA external LSAs.
opaque-area
Use
opaque-area
to display area opaque LSAs.
opaque-as
Use
opaque-as
to display AS opaque LSAs.
opaque-link
Use
opaque-link
to display link opaque LSAs.
router
Use
router
to display router LSAs.
summary
Use
summary
to show the LSA database summary information.
adv-router
Use
adv-router
to show the LSAs that are restricted by the advertising router.
self-originate
Use
self-originate
to display the LSAs in that are self originated. The information
below is only displayed if OSPF is enabled
