Reference Manual for the ProSafe VPN Firewall FVS114
Basic Virtual Private Networking
5-27
202-10098-01, April 2005
Figure 5-32: VPN Status/Log screen
3.
Click
VPN Status
(
Figure 5-32
) to get the Current VPN Tunnels (SAs) screen (
Figure 5-33
).
Click
Connect
for the VPN tunnel you want to activate.
Figure 5-33: Current VPN Tunnels (SAs) screen
Activate the VPN Tunnel by Pinging the Remote Endpoint
Note:
This section uses 192.168.3.1 for an example remote endpoint LAN IP address.
To activate the VPN tunnel by pinging the remote endpoint (192.168.3.1), do the following steps
depending on whether your configuration is client-to-gateway or gateway-to-gateway:
•
Client-to-Gateway Configuration
—to check the VPN Connection, you can initiate a request
from the remote PC to the FVS114’s network by using the “Connect” option in the NETGEAR
ProSafe menu bar. The NETGEAR ProSafe client will report the results of the attempt to
connect. Since the remote PC has a dynamically assigned WAN IP address, it must initiate the
request.
To perform a ping test using our example, start from the remote PC:
Summary of Contents for FVS114NA
Page 4: ...202 10098 01 April 2005 iv...
Page 12: ...202 10098 01 April 2005 xii Contents...
Page 211: ...Reference Manual for the ProSafe VPN Firewall FVS114 Glossary 11 202 10098 01 April 2005...
Page 212: ...Reference Manual for the ProSafe VPN Firewall FVS114 12 Glossary 202 10098 01 April 2005...
