NP727 User’s Manual V1.00
4.2.8 Site Survey
If
Universal Repeater
function is enabled, the system can scan and display all surrounding available access points
(APs). The administrator can then select an AP to be connected to extend its wireless service coverage on this
page.
•
SSID:
The SSID (Service Set ID) of the AP found in the system’s coverage area.
•
MAC Address:
The MAC address of the respective AP.
•
Channel:
The channel number currently used by the respective AP or repeater.
•
Rate:
The transmitting rate of the respective AP.
•
Signal:
The signal strength of the respective AP.
•
Security:
The
encryption type used by the respective AP
•
Setup/ Connect:
¾
Connect:
Click
Connect
to associate with the respective AP directly; no further configuration is required.
¾
Setup:
Click
Setup
to configure security settings for associating with the respective AP.
o
WEP:
Click
Setup
to configure the WEP setting for associating with the target AP.
The following configuration box will then appear at the bottom of the screen.
Security settings
configured here must be the same as
the
target
AP
.
Summary of Contents for INFRASTRUCTURE SERIES
Page 1: ...NetComm INFRASTRUCTURE Series In wall Wireless Access Point USER GUIDE...
Page 3: ...NP727 User s Manual V1 00 4 5 3 Repeater Information 62 4 5 4 Event Log 61 4 6 Online Help 62...
Page 13: ...NP727 User s Manual V1 00 Step 4 Cover it with faceplate...
Page 51: ...NP727 User s Manual V1 00 Layer 2 Firewall Overview Check State...
