Information needed
Your value
Static IP address you plan to use for the
appliance Storage Node on the Grid Network
Note:
If your network does not have a
gateway, specify the same static IPv4 address
for the gateway.
•
IPv4 address (CIDR):
•
Gateway:
Grid Network subnets (CIDRs)
Table 5: Information needed to connect the SG6000-CN controller to the Client
Network
The Client Network for StorageGRID is an optional network, typically used to provide client
protocol access to the grid. The appliance connects to the Client Network using the 10/25-GbE ports
on the SG6000-CN controller.
Information needed
Your value
Client Network enabled
Choose one:
•
No (default)
•
Yes
Network bond mode
Choose one:
•
Active-Backup (default)
•
LACP (802.3ad)
VLAN tagging enabled
Choose one:
•
No (default)
•
Yes
VLAN tag
(If VLAN tagging is enabled)
Enter a value between 0 and 4095:
DHCP-assigned IP address for the Client
Network, if available after power on
•
IPv4 address (CIDR):
•
Gateway:
Static IP address you plan to use for the
appliance Storage Node on the Client Network
Note:
If the Client Network is enabled, the
default route on the controller will use the
gateway specified here.
•
IPv4 address (CIDR):
•
Gateway:
Table 6: Information needed to connect the SG6000-CN controller to the BMC
management network
You can access the BMC interface on the SG6000-CN controller using the following 1-GbE
management port. This port supports remote management of the controller hardware over Ethernet
using the Intelligent Platform Management Interface (IPMI) standard.
Preparing for installation | 29
Summary of Contents for SGF6024
Page 2: ......
