Table 3: Information needed to connect and configure the 10/25-GbE ports on the
SG6000-CN controller
The four 10/25-GbE ports on the SG6000-CN controller connect to the StorageGRID Grid Network
and the optional Client Network.
Information needed
Your value
Link speed
Choose one:
•
Auto (default)
•
10 GbE
•
25 GbE
Port bond mode
Choose one:
•
Fixed (default)
•
Aggregate
Switch port for port 1 (Client Network for Fixed
mode)
Switch port for port 2 (Grid Network for Fixed
mode)
Switch port for port 3 (Client Network for Fixed
mode)
Switch port for port 4 (Grid Network for Fixed
mode)
Table 4: Information needed to connect the SG6000-CN controller to the Grid Network
The Grid Network for StorageGRID is a required network, used for all internal StorageGRID traffic.
The appliance connects to the Grid Network using the 10/25-GbE ports on the SG6000-CN
controller.
Information needed
Your value
Network bond mode
Choose one:
•
Active-Backup (default)
•
LACP (802.3ad)
VLAN tagging enabled
Choose one:
•
No (default)
•
Yes
VLAN tag
(if VLAN tagging is enabled)
Enter a value between 0 and 4095:
DHCP-assigned IP address for the Grid
Network, if available after power on
•
IPv4 address (CIDR):
•
Gateway:
28 | Hardware Installation and Maintenance Guide for SG6000 Appliances
Summary of Contents for SGF6024
Page 2: ......
