Neomatica LLC. Vehicle tracker ADM333BLE GLONASS/GPS. Ver. 1.2 dd 13.07.2019
25
•
Search with the opportunity to choose the sensor type (D), without the filter according to
radio signal level, search time of 120 seconds.
BLEAUTOCATCH D
•
Search with the opportunity to choose the sensor type (D), to switch off the filter according
to radio signal level (F), search time of 120 seconds.
BLEAUTOCATCH D,R
•
Search with the opportunity to choose the sensor type (D), to set the filter according to the
distance (R), search time 120 seconds.
BLEAUTOCATCH D, F, R
•
Search with the opportunity to choose the sensor type (D), to set the filter according to the
distance (R), to choose the search time (T).
BLEAUTOCATCH D,R,T
6.3.3
Adding sensors ADM31, ADM 32 in manual mode, viewing added sensors list
The
BLESENSOR
command allows to add sensor addresses, as well as to view the list of
added addresses. The sensor address is marked on the label placed on the housing.
Don't enter a colon when entering the address.
BLESENSOR X,Y
- add address Y to the cell X, where X=0..4;
BLESENSOR X,0
- clear cell X, where X = 0..4;
BLESENSOR Y
- add address Y to the end of the list;
BLESENSOR 0
- clear the list;
BLESENSOR
– display the list of addresses added to the tracker.
Example of commands input:
BLESENSOR 0,FC61CFEF5E31
– add address FC:61:CF:EF:5E:31 to the cell 0;
BLESENSOR FC61CFEF5E31
– add address FC:61:CF:EF:5E:31 to the end of the list.
6.3.3.1 Data receiving from connected ADM31/32 sensors
The
BLESENSORINFO
command allows to request the latest data received by the tracker
from the sensor.
