Neomatica LLC. Vehicle tracker ADM333BLE GLONASS/GPS. Ver. 1.2 dd 13.07.2019
12
6)
After a few seconds the connection between the tracker and the ADM Configurator
program will be installed and the settings window will be displayed;
7)
After the device is set or, if connection of another tracker is required, click "disable device"
in the upper right corner of the ADM Configurator. The ADM Configurator will go into a
standby mode as shown in the Figure 6.
Figure 6
– ADM Configurator: “disable device button”
5.2 Using configuration commands
The tracker is managed by commands sent via SMS, GPRS or Bluetooth. Commands syntax
is the same for any way of transmission.
General rules of writing and sending commands
:
⎯
only Latin characters and punctuation can be used in commands;
⎯
character case does not matter;
⎯
commands transmission syntax is the same for SMS, GPRS and Bluetooth;
⎯
commands syntax
: «CMD X1,X2,X3», where CMD is a command, X1..X3 are commands
parameters;
⎯
commands are separated by a SPACE. Parameters are separated by commas,
except
for
the
DN0
command which parameters are separated by a colon;
After receiving a command, the tracker performs it and sends a feedback.
If the command parameters extend beyond the acceptable range, the tracker changes them to
the nearest acceptable values. If it is not possible to change parameters or parameters are not
enough, the tracker will answer with an error message. A command without parameters returns the
current settings.
