Neomatica LLC. Vehicle tracker ADM333BLE GLONASS/GPS. Ver. 1.2 dd 13.07.2019
13
⎯
Sending commands using ADM Configurator
To send commands via Bluetooth you should use ADM Configurator. If earlier the tracker under
configuration had a password different from 0, then ADM Configurator will ask for the password.
⎯
Sending commands using SMS
To manage the tracker using SMS, it is necessary to send the SMS command "
ADD
ME 0
" to
the number of the SIM card installed in the tracker, where 0 (zero) is the default
password (if the
password has been changed, you should enter it instead of 0). The phone number from which this
command was sent will be authorized in the tracker. The authorization is done only once, afterwards
the tracker saves the phone number in a non-volatile memory during the whole service life. Maximum
quantity of saved phone numbers is 4. Resetting the settings to the factory ones clears all phone
numbers.
⎯
Sending commands using TCP connection
To configure via GPRS, authorization is not required. The tracker receives the commands
from the server via TCP-connection that is used for data transmission.
5.3 Configuring SIM
Enter parameters of the access point name (APN) in the ADM Configurator graphic interface
for the installed SIM cards or use commands
SETGPRS0
and
SETGPRS1,
the
final digit in a
command name corresponds to the phone number
of a holder’s SIM card.
If the installed SIM card/cards is/are with enabled PIN -code, then enter this PIN-code in the
ADM Configurator graphic interface or use commands
PIN0
and
PIN1,
the
final digit in a command
name corresponds to the phone number of
a holder’s SIM card. This PIN-code will be automatically
entered each time a Sim card initialization is required.
There is an opportunity to select a priority SIM card when using two Sim cards. If the priority is
set, then the tracker connecting to the server using a non-priority SIM card, will work via it for 30
minutes, then will switch to the priority one and, if the connection to the server is established, will
work via it without time limit. The priority is set in the graphic interface of the ADM Configurator or
using
SIMPRIORITY
command. By default, priority is not set.
