Code 4420026
Edition no. 1 of 1
st
March 2006
Printed on 13/07/2006
Page 8
3. Press the button on the new radio control device to be
assigned to the actuator. The activator pilot light will start
to flash as soon as the key is released.
4. The pilot light should stop flashing.
5. Programming is now complete. All commands are ready for normal function.
Memorising commands for the radio operated P2/R rain sensor
The
P2/R
rain sensor commands all memorised motors within 60m out in the open
area
(walls, metal panels, iron cages etc all drastically reduce capacity).
Memorising commands for the radio operated
P2/R
rain sensor for the KATO
RADIO actuator follows a similar procedure to that used for the radio operated
remote control, as follows:
A. Set dip-switch n°
1
to
ON.
The red led pilot light will t urn on. Set the dip -
switch immediately to
OFF
.
B. Touch the sensitive area of the sensor
(shaped in the form of the letter N)
with your hand or a wet cloth for around 1 second. There is no
danger of
electrical shock as the sensitive area has no electricity su pply.
C. The led pilot light will stop flashing .
D. Programming is complete. The rain sensor will be ready to function in 2 minutes
.
PROGRAMMING THE ACTUATOR
The actuator comes out of factory “NOT PROGRAMMED”
. It must be programmed
to apply commands from the ra dio operated remote control or rain sensor and must
also be programmed to stop at the end course point required by the user.
Programming is carried out using the dip -switches
(4 in total)
on the side of the actuator
opposite the feeder cable. On the left o f the opening is a led light t o indicate functions in
course. The following designs indicate the meanings and position of the dip
-switches:
x
Programming phase…………….…….............................
x
Programming of course to 100 mm …………………………..
x
Programming of course to 200 mm ……………………..
x
Programming of course to 300 mm ……………………..
x
Programming of course to 400 mm ……………………..
