Code 4420026
Edition no. 1 of 1
st
March 2006
Printed on 13/07/2006
Page 7
the feeder cable. The commands for
OPEN
and
CLOSE
are controlled by electrically
connected radio operated remot e control device on 433.92 MHz.
REMOTE CONTROL DEVICES (Radio operated remote control and Rain
sensor)
The radio operated remote control device is the only device used for manually
controlling the actuator. The KATO RADIO model has been designed without any
switch or button commands.
The
BLU’R
radio operated remote control has four command buttons, 433.92MHz
transmitter, rolling code, 16 billion billion combinations. Transmitter cloning is
impossible as the code changes at each transmission according to an algorithm which
masks the code.
As the codes used are rolling, each transmitter will transmit a different signal. The
receiver must therefore be able to recognise the transmitters enabled
.
Each key on the radio operated remote control corresponds to a motor control
which will be memorised by the operator
(see following paragraphs )
.
Another remote control electronic command device is the radio operated
P2/R
rain
sensor
(For installation of the P2/R rain sensor, see the “installation and use
manual” provided in the box of the sensor packaging
)
.
W
ARNING
.
THE ONLY RAIN SENSOR WHICH CAN BE USED IS THE RADIO OPERATED
P2/R –
OTHER
MODELS WILL NOT FUNCTION
.
T
HE SUPPLY CABLE HAS ONLY
2
WIRES CONNECTED
(
WHITE
(+),
YELLOW
(-)
The two devices (radio operated remote control and rain sensor) cannot be
programmed at the same time.
The receiver can memorise up to
8
transmitters. Any number of transmitters over
and above this will not be accepted.
Memorising radio commands; actuator dip-switches accessible.
WARNING
:
NEVER ASSIGN THE SAM E KEY TO MORE THAN O NE ACTUATOR
1. Set dip-switch n°
1
to
ON.
The red led pilot light will turn on. Set the dip -
switch immediately to
OFF
.
2.
Press the key to be assigned to the actuator until the led pilot light starts to
flash.
3. The led pilot light will stop flashing.
4. Programming is co mplete, all commands are ready or ready for normal
function.
Memorising another radio control device; dip-switch NOT accessible.
1. Press buttons 1, 2, and 4 on the radio control device for
around 1 second, then press the key to command the
actuator.
2. The red pilot light on the actuator will come on.
