P2595EN01
08 - 2007
TECHnICIAn MEnu
41
6
gsm
The control software can send, via GSM modem, a signal indicating
a machine failure or an “ending product” “pre-alarm”, after dis-
pensing a certain (programmable) number of selections of a given
product.
6.1
gsm P
In
code
This function is used for programming the identification code that
will be sent to the GSM modem (optional) when switching the ma
-
chine on.
6.2
gsm
Pre
-
alarms
6.2.1
P
re
-
alarms
thresholds
This function is used for defining the number of pieces or grams of
powder for a given product, after which a “running-out” “pre-alarm” is
signalled via modem.
6.2.2
r
esettIng
the
Pre
-
alarm
counters
With this function the counters that control the pre-alarms are reset.
6.3
b
ank
number
The number in the bank of machines (1 to 7) that identifies the
machines that have the “slave GSM” function, therefore sending
data via the “master” machine modem .
The number 0 identifies the machine that is connected directly to
the modem, i.e. the “master GSM”..
6 - GSM
6.1 - GSM PIN CODE
6.2 - GSM PRE-ALARMS
6.2.1 - PRE-ALARM THRESH
6.2.2 - RESET PRE-AL CNT
6.3 - GROUP NUMBER
5.4.3 - V.M. SELECTION
5.4.3
v
endIng
machIne
selectIon
This function is enabled only if the machine is installed in a bank
with one or more Minisnakky / Snakky / Snakky SL.
It is used for selecting the vending machine in the bank of machines
on which to operate with the Up-Key (Brio3 or Minisnakky or Snakky
o Snakky SL).
