P2595EN01
08 - 2007
I
ntroductIon
This “Programming Manual” is a very useful tool for those operators who want to get the most out of the poten-
tial of the installed software and know in detail all of the available software functions.
This document is available in PDF format in the Reserved Area of our internet site
www.nwglobalvending.com or, on request, through our after-sales service.
The Manual is divided into 3 parts:
The First Part regards
Normal Vending Mode
; it describes the operations to be carried out during the vending
machine normal use:
- Power-on
- Operations with the door closed
- Messages for the user.
The Second Part descries the
Filler Menu
, the programming part that is used for changing individually the
sales prices of the selections and for simple controls on the functioning and on the machine sales.
The Third Part describes the
Technician Menu
, the programming part that is meant for technical personnel,
used for changing the machine performance.
The operations described can modify the functioning cycles, therefore they must be carried out only by per-
sonnel who have the specific knowledge of the machine functioning from a point of view of electrical safety
and health regulations.
The appendix contains the
List of Failures
, which describes the possible error signals and the self-diagnosis
conditions of the machine; it also describes the functions concerning the coin mechanism communication
protocols.
normal
vendIng
mode
P
ower
o
n
When closing the machine door, the display indicates the version number of the installed software.
The machine can be programmed for displaying, for a few second, the number of selections made.
After a few seconds the display will show the message “
Heating
” and when the normal operating temperature
is reached, the machine goes into normal vending mode.
o
PeratIons
wIth
the
door
closed
During Normal Vending Mode it is possible to carry out certain operations with the door closed, keeping button
A pressed for more than 2 seconds (see figure). The push-buttons take on numeric values as shown in the
figure:
A
The machine waits a few seconds for the entry of a 5-digit
code that will allow the following operations if enabled in
the Password option within the Technician Menu:
- Reset counters
- Wash
By default all passwords are disabled.
